TweakTown
Tech content trusted by users in North America and around the world
6,252 Reviews & Articles | 40,828 News Posts
TRENDING NOW: Sony teases PlayStation 5 could be a cloud-based console

Cooler Master USP 100 (RC-P100-RKR1) Mid Tower Case - Accessories and Documentation

On a budget for a new gaming build? Cooler Master's USP 100 might just be the budget friendly case of choice.

| Mid-Tower Cases in Cases, Cooling & PSU | Posted: May 27, 2010 4:06 pm
TweakTown Rating: 94%Manufacturer: Cooler Master

Accessories and Documentation

 

TweakTown image content/3/3/3308_20.jpg

 

Inside of the cardboard box that was stuffed in the hard drive bays is where you will find these goodies. There are three smaller, tool-less clips for the 3.5" drives and five clips for the 5.25" bays. Above them is the floppy drive cover to swap out with a full cover, if you install a floppy drive that is. To the left there are seven screws for mounting hard drives if the clips aren't enough, and the same goes for four screws for optical drive mounting. To the right side there are thirteen screws for motherboard mounting or replacing lost PSU or panel screws. That leaves the two extra risers and an extra thumbscrew to finish it all off.

 

TweakTown image content/3/3/3308_21.jpg

 

There is a fold out sheet of instructions to help you through the build process. Once I skimmed it as I took this image; I had no need to refer to it later as the case is pretty intuitive.

 

TweakTown image content/3/3/3308_22.jpg

 

Here I removed the power supply just so I could show it off a little, as it is rough to do inside the chassis. There are plenty of leads and an included power cord, so getting this up and running should be a snap.

 

TweakTown image content/3/3/3308_23.jpg

 

Here you can get a bit of information about what the power supply is capable of powering. Two +12V lines at 15A each isn't going to run Fermi's in SLI, but it should hold its own with most single GPU builds and has potential for say a pair of HD 5770's.

 

TweakTown image content/3/3/3308_32.png

 

Just in case you wanted to know a bit more about the power supply, other than what the basic sticker information explains.

 

TweakTown image content/3/3/3308_24.jpg

 

I just wanted to lay out the wiring so it was a bit easier to see the lines and connections. In case you are wondering, the leads are about fourteen inches to the first connection, and if they branch, the sections are roughly six inches each. Plenty to get around inside of the USP 100!

 

Related Tags

Further Reading: Read and find more Cases, Cooling & PSU content at our Cases, Cooling & PSU reviews, guides and articles index page.

Do you get our RSS feed? Get It!

Got an opinion on this content? Post a comment below!

Latest News Posts

View More News Posts

Forum Activity

View More Forum Posts

Press Releases

View More Press Releases