Thermal Imaging and Power Consumption
System power is measured at the wall with an AC power meter.
Note on Thermal Images: In the temperature section, we use our Seek thermal imaging camera to capture the surface temperatures of major components on the board. I look at the VRM and then all other things that light up the screen. If there is something to worry about, then I will state it. Otherwise, I will just show the hotter running parts of the board for fun. Unless some component is over 80-90C, then there isn't anything to worry about.
All systems will act differently, so I will look for commonalities, such as how far from the VRM the heat spreads through the PCB and the difference in temperature between the front side and backside of the PCB. Keep in mind, the majority of the heat from the VRM goes into the PCB as it is a giant soldered on copper heat sink. A larger difference in temperature between the back and front of the PCB points towards a more effective heat sink.
Thermal Testing at Stock Speeds:
The image on the left is always at idle, and the image on the right is at load. During ALL TESTS, fans to the right of the motherboard from the (Corsair H110i) radiator are left in automatic mode (ramps with internal block temperature). Additionally, a 120mm fan is situated right above the VRM, and it blows down at a medium rate (very quiet). Thermal Images are taken at loop 15 of Intel Burn Test
Up-close of the front of the VRM.
Up-close of the back of the VRM.
Thermal Testing at 4.9GHz/1.3v Overclocked Speeds:
The image on the left is always at idle, and the image on the right is at load. During ALL TESTS, fans to the right of the motherboard from the (Corsair H110i) radiator are left in automatic mode (ramps with internal block temperature). Additionally, a 120mm fan is situated right above the VRM, and it blows down at a medium rate (very quiet). We standardize this test with a 4.9GHz on all cores with 1.3V real under load and take pictures at the 80% mark of HandBrake rendering a 4K video.
Up-close of the front and back of the VRM.
The Z370N WIFI's VRM is not the most robust, has four phases for the VCore with three MOSFETs per phase, but it can get the job done with good airflow all around. However, we see some of the highest VRM temperatures at the 70s on the front and 80s on the back when we take our 8700K to 4.9GHz. Now, this is acceptable but is not the best, but we cannot expect too much better from mini-ITX motherboards. The good news is that it didn't throttle the overclock. Anything under 60C is great, 60-80C is acceptable, and anything above 80C is a bit worrisome (if at stock).
PRICING: You can find the product discussed for sale below. The prices listed are valid at the time of writing, but can change at any time. Click the link below to see real-time pricing for the best deal:
United States: Find other tech and computer products like this over at the Amazon website.
United Kingdom: Find other tech and computer products like this over at the Amazon UK website.
Canada: Find other tech and computer products like this over at the Amazon Canada website.
- Page 1 [Introduction, Specifications, and Pricing]
- Page 2 [Packaging and Z370N WIFI Overview]
- Page 3 [GIGABYTE Z370N WIFI Circuit Analysis]
- Page 4 [GIGABYTE Z370N WIFI Circuit Analysis Continued]
- Page 5 [BIOS and Software]
- Page 6 [Test System Setup]
- Page 7 [Overclocking]
- Page 8 [CPU, Memory, and System Benchmarks]
- Page 9 [System IO Benchmarks]
- Page 10 [Thermal Imaging and Power Consumption]
- Page 11 [What's Hot, What's Not & Final Thoughts]