Inside the P7-C0
The front bezel will pull off the chassis via a gap at the bottom of it, and it exposes the front of the chassis. On the front, we see a full-length dust filter, which is magnetically attached at the right, and swings open to the left, at which time the tabs come out for easy cleaning. Sadly though, there is a wire connected to the bezel, which powers the LED ring and does not go far once the wires are managed.
Upon initially looking into the P7-C0, we find that the entire case is one large open area, that is, except for what is covered with the PSU shroud. Also, so far, no hints of paperwork or literature.
Inside of the front panel, we find that there are no fans to be found pre-installed. However, you do have the option to use a trio of 120mm fans or a pair of 140mm fans, and there is also room for a thin radiator for the 360mm option, and for smaller ones, you could opt for thicker radiators.
Once we removed the dust filter, we can see all of the mounting holes as well as the open honeycomb mesh used. At either end are short slots for 120mm and 140mm fans, while in the middle are longer slots to help with various screw offsets on radiators.
The motherboard tray comes with all of the standoffs in place for use with an ATX motherboard and has a large hole for CPU backplate access. There are twelve locations with tie-points, and the right third of the tray is inset with a large gap running down it to pass wires through to this area.
The PSU shroud is plain looking, but the idea is to block the view of what goes under it, and it does that well. There is a gap at the front to allow for cooling with holes in the front edge of the shroud and louvers at the top to keep HDDs cool. While most of it is an expanse of textured black steel, we do see three holes to aid in wiring the motherboard as well as providing a location for GPU power leads.
PRICING: You can find the product discussed for sale below. The prices listed are valid at the time of writing, but can change at any time. Click the link below to see real-time pricing for the best deal:
United States: The Aerocool Project 7 P7-C0 Mid-Tower Chassis retails for $XXX at Amazon.
United Kingdom: Find other tech and computer products like this over at Amazon UK`s website.
Recommended for You
- We at TweakTown openly invite the companies who provide us with review samples / who are mentioned or discussed to express their opinion of our content. If any company representative wishes to respond, we will publish the response here.
Latest News Posts
- Bitcoin hits $6000, with $100 billion in value
- Galaxy S9: 6GB RAM, headphone jack is a selling point
- Mass Effect dev: EA only cares about highest returns
- Gabe Newell is the 427th richest person in the world
- Sharp NES TV: a curious piece of 1980s gaming magic
- ex58-UD3R rev 1.6
- RAID on a new X370 Fatal1ty Gaming X with m.2 SSDs using a PCIe card.
- LGA-775 GA-EP35-DS3P (rev 2.1), Q9550 e0 overclocking advice please?
- Will the PC-A76 accept a Tyan TYAN S7100 (S7100AG2NR) SSI EEB Mother board?
- MSI Z370 GODLIKE GAMING Motherboard Review
- Introducing the CYBERPOWERPC Crystal Gaming Series Powered By CORSAIR
- COLORFUL Officially Releases iGame Z370 Vulcan X Motherboard in South Korea
- G.SKILL Releases DDR4-3800MHz 32GB (4x8GB) SO-DIMM Memory Kit for Mini-ITX Motherboards
- EK Water Blocks releases new Slim Series kits
- BIOSTAR releases new RACING Z370GT7 motherboard