Technology and gaming content trusted in North America and globally since 1999
8,587 Reviews & Articles | 67,031 News Posts

Patriot Ignite M2 480GB SATA III M.2 SSD Review (Page 6)

By Jon Coulter on May 5, 2015 at 09:07 pm CDT - 4 mins, 44 secs reading time for this page
Rating: 86%Manufacturer: Patriot Memory

Futuremark PCMark 8 Extended - Consistency Test

Heavy Usage Model

We consider PCMark 8's consistency test to be a heavy usage model test. This is the usage model most enthusiasts, heavy-duty gamers, and professionals fall into. If you do a lot of gaming, audio/video processing, rendering, or have workloads of this nature, then this test will be most relevant for you. PCMark 8 has built-in, command line executed storage testing. The PCMark 8 Consistency test measures the performance consistency and the degradation tendency of a storage system.

The Storage test workloads are repeated. Between each repetition, the storage system is bombarded with a usage that causes degraded drive performance. In the first part of the test, the cycle continues until a steady degraded level of performance has been reached. (Steady State)

In the second part, the recovery of the system is tested by allowing the system to idle and measuring the performance after 5-minute long intervals. (Internal drive maintenance: Garbage Collection (GC)) The test reports the performance level at the start, the degraded steady-state, and the recovered state, as well as the number of iterations required to reach the degraded state and the recovered state.

We feel Futuremark's Consistency Test is the best test ever devised to show the true performance of solid-state storage in a heavy usage scenario. This test takes on average 13 to 17 hours to complete, and writes somewhere between 450GB and 14,000GB of test data depending on the drive. If you want to know what an SSD's performance is going to look like after a few months or even years of heavy usage, this test will show you.

Here's a breakdown of Futuremark's Consistency Test:

Precondition phase:

1. Write to the drive sequentially through up to the reported capacity with random data.

2. Write the drive through a second time (to take care of overprovisioning).

Degradation phase:

1. Run writes of random size between 8*512 and 2048*512 bytes on random offsets for 10 minutes.

2. Run performance test (one pass only).

3. Repeat 1 and 2 for 8 times, and on each pass increase the duration of random writes by 5 minutes.

Steady state phase:

1. Run writes of random size between 8*512 and 2048*512 bytes on random offsets for 50 minutes.

2. Run performance test (one pass only).

3. Repeat 1 and 2 for 5 times.

Recovery phase:

1. Idle for 5 minutes.

2. Run performance test (one pass only).

3. Repeat 1 and 2 for 5 times.

Storage Bandwidth

PCMark 8's Consistency test provides a ton of data output that we use to judge a drive's performance.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 43 | TweakTown.com

We consider steady state bandwidth (the blue bar) our test that carries the most weight in ranking a drive/arrays performance. Performance after Garbage Collection (GC) (the orange and red bars) is what we consider the second most important consideration when ranking a drives performance. Trace based steady state testing is where true high performing SSDs are separated from the rest of the pack.

The Ignite M2 isn't designed for heavy workloads. Its lower write speed and lack of parallelism is holding it back in this test. The S10 is capable of a lot more.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 44 | TweakTown.com

We chart our test subject's storage bandwidth as reported at each of the test's 18 trace iterations. This gives us a good visual perspective of how our test subjects perform as testing progresses.

Total Access Time (Latency)

We chart the total time the disk is accessed as reported at each of the test's 18 trace iterations.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 45 | TweakTown.com

Disk Busy Time

Disk Busy Time is how long the disk is busy working. We chart the total time the disk is working as reported at each of the tests 18 trace iterations.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 46 | TweakTown.com

When latency is low, disk busy time is low as well.

Data Written

We measure the total amount of random data that our test drive/array is capable of writing during the degradation phases of the consistency test. Pre-conditioning data is not included in the total. The total combined time that degradation data is written to the drive/array is 470 minutes. This can be very telling. The better a drive/array can process a continuous stream of random data, the more data will be written.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 47 | TweakTown.com

Sequential write speed is much less of a factor in this aspect of our test. The Ignite's S10 controller has 3 of its 4 cores dedicated to flash management and this segment of our test shows the controller is doing a good job of cleaning up the drives flash array as testing progresses.

70/30 Mixed Workload Test (Sledgehammer)

Version and / or Patch Used: Iometer 2014

Heavy Usage Model

This test hammers a drive so hard we've dubbed it "Sledgehammer". Our 70/30 Mixed Workload test is designed to simulate a heavy-duty enthusiast/workstation steady-state environment. We feel that a mix of 70% read/30% write, full random 4K transfers best represents this type of user environment. Our test allows us to see the drive enter into and reach a steady state as the test progresses. Phase one of the test preconditions the drive for 1 hour with 128K sequential writes. Phase two of the test runs a 70% read/30% write, full random 4K transfer workload on the drive for 1 hour. We log and chart (phase two) IOPS data at 5-second intervals for 1 hour (720 data points). 60 data points = 5 minutes.

Patriot Ignite M2 480GB SATA III M.2 SSD Review 48 | TweakTown.com

What we like about this test is that it reflects reality. Everything lines up, as it should. Consumer drives don't outperform Enterprise-Class SSD's that were designed for enterprise workloads. Consumer drives based on old technology are not outperforming modern Performance-Class SSD's, etc.

We see drive maintenance kicking into high gear at about data point 600. The Ignite M2 is performing slightly better than our HyperX Savage, but lower than the others on our chart.

Last updated: Nov 15, 2019 at 01:16 pm CST

PRICING: You can find products similar to this one for sale below.

USUnited States: Find other tech and computer products like this over at Amazon.com

UKUnited Kingdom: Find other tech and computer products like this over at Amazon.co.uk

AUAustralia: Find other tech and computer products like this over at Amazon.com.au

CACanada: Find other tech and computer products like this over at Amazon.ca

DEDeutschland: Finde andere Technik- und Computerprodukte wie dieses auf Amazon.de

Jon Coulter

ABOUT THE AUTHOR - Jon Coulter

Jon Coulter became a computer enthusiast about the time Windows XP launched. Originally Jon was into water cooling and competitively benching ATI video cards with modified drivers. Jon has been building computer systems for himself and others by request for more than 10 years. Jon became a storage enthusiast the day he first booted his system with an Intel X25-M G1 80GB SSD. Look for Jon to bring consumer SSD reviews into the spotlight.

We openly invite the companies who provide us with review samples / who are mentioned or discussed to express their opinion. If any company representative wishes to respond, we will publish the response here. Please contact us if you wish to respond.

Related Tags