Inside the Elite 110
After removing the panels to access the interior of this chassis, we see that they have tied up some hardware as well as bundled the wiring to keep it all secure for transit.
We also removed the bezel to show the 120mm fan that they have supplied in this chassis. Thing is, we did not realize how handy the holes and wire management options were at this point, but once the build was underway, these will tend to wiring and offer a place to hide things.
The left side offers a frame component that has a lot of features. This will house either two 2.5-inch drives or a single 3.5-inch drive at the top, and it can also house a pair of 80mm fans at the bottom while still leaving the top storage drive with enough room to be used.
Across the top of the chassis, there is a removable plate that is much like the left side. This will allow the installation of a pair of 3.5-inch drives or a pair of 2.5-inch drives. That is now a total of four 2.5-inch drives, three 3.5-inch drives, or a combination of both.
Removing that top plate allows complete access to the motherboard tray. There are only a few inches on the three sides combined, but they do offer seven places to tie down the wiring in addition to the four holes that we need to install standoffs in to set the motherboard on.
All of the wiring for the Elite 110 is attached to the front bezel. In perspective, the audio, USB 3.0 with USB 2.0 tail on it, and the front panel wiring do look short, but once this bezel is lying in front of the chassis, we were able to make all of the connections with the bezel off and were able to tend to them easily enough.
PRICING: You can find products similar to this one for sale below.
United States: Find other tech and computer products like this over at Amazon's website.
United Kingdom: Find other tech and computer products like this over at Amazon UK's website.
Canada: Find other tech and computer products like this over at Amazon Canada's website.
- Page 1 [Introduction, Specifications and Pricing]
- Page 2 [Packaging]
- Page 3 [Cooler Master Elite 110 Mini-ITX Chassis]
- Page 4 [Inside the Elite 110]
Recommended for You
- We at TweakTown openly invite the companies who provide us with review samples / who are mentioned or discussed to express their opinion of our content. If any company representative wishes to respond, we will publish the response here.
Latest News Posts
- Bitcoin hits $6000, with $100 billion in value
- Galaxy S9: 6GB RAM, headphone jack is a selling point
- Mass Effect dev: EA only cares about highest returns
- Gabe Newell is the 427th richest person in the world
- Sharp NES TV: a curious piece of 1980s gaming magic
- RAID on a new X370 Fatal1ty Gaming X with m.2 SSDs using a PCIe card.
- LGA-775 GA-EP35-DS3P (rev 2.1), Q9550 e0 overclocking advice please?
- Will the PC-A76 accept a Tyan TYAN S7100 (S7100AG2NR) SSI EEB Mother board?
- MSI Z370 GODLIKE GAMING Motherboard Review
- GTX 1080 Ti 11GB - SLI or NOT !?
- Introducing the CYBERPOWERPC Crystal Gaming Series Powered By CORSAIR
- COLORFUL Officially Releases iGame Z370 Vulcan X Motherboard in South Korea
- G.SKILL Releases DDR4-3800MHz 32GB (4x8GB) SO-DIMM Memory Kit for Mini-ITX Motherboards
- EK Water Blocks releases new Slim Series kits
- BIOSTAR releases new RACING Z370GT7 motherboard