The Build and Finished Product
I would have liked to install the DVD drive into the top slot so I wouldn't break up the louvers. I found that due to the wiring from the touch panel, this is not an option. However, the tool-less clip worked flawlessly, and the break isn't all that horrendous.
Packed with all my components, the super tower is brought down to size. There is plenty of room for the motherboard, cards, and the PSU to go in with little effort. With the hard drives, keep in mind that there isn't a fan grill on the front fan, and I wish there was one, as the wiring naturally wants to be here.
Here is the wing I showed earlier, just now it has been relocated and the latch is set to lock it in place. You can replace the three screws, but this rack stays in place fine without them, and it makes later use much easier.
Aside from the colorful I/O shield, four DVI ports, and the southbound end of a northbound power supply, the obvious thing left is to plug in the external USB 3.0 wire into the rear I/O so that you have it for the front I/O. I would have expected this to be a 20-pin internal connection.
Behind the scenes I didn't do too much. It is always easier to route the 8-pin behind the board, and the 787 allows this rather easily. The rest is up to you as most of the wiring is already up front.
I just wanted to show you how the grill in the right side panel lines up with the socket of my motherboard. While mine isn't the golden rule, it is good to see that adding a fan here would do what it is intended for, cooling the back of the CPU socket.
Here is the Xclio touch 787 ready for power with everything packaged back up, doors placed on, and hopefully wired correctly inside. Now, where did that power cord get to?
When the chassis is first powered, there is an audible beep noting you did so. At this time the entire touch panel illuminates, but the fans in the chassis start to spin at half speed with dim LED lighting at this stage.
After just a second or two, the Xclio Touch 787 comes to life, and the glow of blue LED is everywhere. The bright glow out the door, the roof, and the rear are sure to add a blue cast throughout the room. Down the front there isn't much in the way of lighting, at least until the very bottom. There are two lights designating power while a third one will flicker with hard drive activity.
PRICING: You can find products similar to this one for sale below.
United States: Find other tech and computer products like this over at Amazon's website.
United Kingdom: Find other tech and computer products like this over at Amazon UK's website.
Canada: Find other tech and computer products like this over at Amazon Canada's website.
Recommended for You
- We at TweakTown openly invite the companies who provide us with review samples / who are mentioned or discussed to express their opinion of our content. If any company representative wishes to respond, we will publish the response here.
Latest News Posts
- Xiaomi Redmi Note 4 explodes and catches fire
- NVIDIA CEO hands out first Tesla V100s to AI researchers
- ADATA's new XPG SPECTRIC D40: RGB DDR4 for X299
- Battlegrounds made more than Overwatch on PC last month
- Intel Core i9-7920X: 12C/24T @ 4GHz, 140W TDP, and $1199
- GIGABYTE X299 AORUS Gaming 7 Motherboard Review
- Comic-Con 2017 trailer round-up: MCU vs DCEU vs the rest
- graphics card not detected via riser cable
- Maximum ratio (x39) with 4,06GHz for i7 4770 on GA Z87X-UD3H?
- Supermicro SuperO Booster Software Guide
- ADATA Debuts XPG SPECTRIX D40 RGB DDR4 RAM
- Atari announces Blade Runner 2049 partnership with NECA and Audiowear, launching wearable technology that blurs the line between fashion and future
- BIOSTAR introduces the world's first 8-slot PCI-e mining motherboard with the TB250-BTC+
- HyperX unveils HyperX Alloy Elite and TKL HyperX Alloy FPS Pro mechanical gaming keyboards
- Toshiba Memory Corporation develops world's first 3D flash memory with TSV technology