Today Mikhailtech review a ZXMods small Obround window by modding an Antec case with it. The shape is a bit different from other kits as well.
After setting up my work area outside, it was time to cut. Don't forget safety equipment, especially safety glasses or goggles. I would have preferred to use my jigsaw with a metal cutting blade on this mod, but it died when I took it out to test it. This left no choice but to use the Dremel. Two reinforced cut-off disks were all needed to make quick work of the case. I took the advice of someone who emailed me after my blowhole mod and I let the tool do the work. Instead of the case chewing through the disk, the disk chewed through the case. Slow down to speed up, sounds good to me.More information at Mikhailtech
Recommended for You
Got an opinion on this news? Post a comment below!